Bryant Furnace Reset Button

Where does Bryant's race start again? 3

It takes a few seconds to warm up, then the flame goes out and the fan keeps running. I once had this problem and the solution was to change the filter and reconfigure the switch. I changed the filter.

But I don't remember where to start. I am not using the device yet so I do not have the correct model number. Also, the light will flicker at 3 intervals like the last time I had this problem. Thanks in advance for any of your help.

I had this problem with the same type of device. Remove the cover from the base of the device, remove the wall plug (plug).

Carefully remove the thermocouple and use steel wool to clean the metal sensor. It is made with charcoal and needs to be cleaned when the device is turned on. Be careful not to ignite the coil as it is made of breakable ceramic. The sensor is 1/8 inch thick and its rod can be 3 inches long. You will need a Phillips screwdriver to remove it. Restart is on the map on the left.

Bryant User Guide

Bryant Furnace Reset Button

I don't have an answer to this problem, but I can warn you that 20 years after your Bryant was made to look like me, the wires running under the heating chamber could break and sometimes a loose thermostat. Connections can be made. No trace it didn't work and I bought a new one about 10 years ago. My machine is less than 40 years old and there are no iron tubes in the heating chamber. I replaced this ugly fan and yarn in 30 years.