How To Straighten Wire
What is the best way to straighten wire hangers? 3
I wanted to do something with wire hangers because we have a lot of them. But I'm happy to remove the little PS, it seems impossible to fix it after folding. Thoughts?
It should not take much time, you do not have to go to the sector every time, you have to use tweezers to open the wound, then straighten it with hammer, it is not so difficult, you get well. Will
I have been doing this with both hands for 50 years. There is a learning curve, but practice is fine.
The biggest problem is that you can prevent the cable from twisting while you are working.
For very stiff wires, I use two tongs to reduce the pressure on my fingers. With one hand, hold the wire 1/4 inch from one end of the elbow and hold the other 1/4 to 1/2 inch clamp in the fold of the first clamp to avoid twisting the wire and straighten the hazard while holding the hazard. Hold carefully. .
When bending metal, you should bend slightly from the desired bending point, as the metal will break easily when pressure is released. It takes time and experience to figure out how much twist is needed for each type of yarn found.
With practice and experience, you can get straight wire cuts without having to buy expensive straighteners.
It depends on what you want to do. It heats the wire (filming board?) Then, as the metalworkers once did, it hit the wire with a hammer and a suitable piece of metal and worked. Any tweezers etc. that you feel will get you the justice you want. Find your local tool center ...
I also saw:
The easiest way to do this is to place the hanger in a working position. Use thread pliers to loosen or cut the spiral. The smaller PS can be straightened by rotating the hanger in the way and pressing with the way handle.
