Razor Scooter Clicks But Wont Go

My electric shaver E100 does not work?

Troubleshooting and FAQ for E100 / e125 / e150 Shaver

I. Location of Circuit Identifier:

The uct is identified not only on the uct loader, but also under the control tube and the uct.

II.E100 / 125/150 Intermittent operation: The device switches on and off during use. Please try the following:

Slowly slide the cable around the throttle to find the loose pile of cables. If the device is closed by loose / unstable wires, the throttle must be replaced.

loose € Loose Remove the battery / engine cover to check for loose contacts. If any contacts are loose, reconnect them.

I am. E100 / 125/150 does not work:

* Always make sure that the charger is properly connected to the charging port and the LED charger is working properly.

* This device can be charged up to 18 hours after first use and up to 8 hours after each subsequent use.

The engine will not start. Please try the following:

Press 3 miles per hour (in SD) to speed up the rating.

Don't forget to press s while changing the throttle control.

It shuts down during use. Please try the following:

. Turn off the device, wait a few minutes and press reset.

. The power switch is on and working.

. Do not try to overweight, climb hills, or pull things. It is best to avoid this condition at all times.

The power switch is not on. The motor is not activated during kicking. Please try the following:

cover € Inspect the loose gasket under the cover plate.

. * If contacts are loose, reconnect them.

. Â If there are no loose contacts, replace the reset / power switch.

The motor starts but does not move (E150 only) Please try the following:

Check the € the chain and rear wheel Â a.

Â Â If the chain rotates but the rear wheel does not move, replace the rear wheel.

The device works but does not work after charging. The power switch is on. Please try the following:

safe € œ A safety unit starts and goes off, takes a breath and turns the rear wheel manually when you speed up

. € f If the engine starts, replace the battery.

Â Â If engine does not start, replace control module and throttle body.

quiet. Do not stay silent. Press E100 / 125/150.

E100 ss series requires S stick. When the engine stops, it does not start.

. Turn on the device.

Â Press S with your feet. Make sure your body roll is good (less than 3 miles per hour). Watch the video.

€ Press the accelerator pedal.

. * The engine starts now.

V. E100 / 125/150 without use

Closes during use Try the following:

. Turn off the device, wait a few minutes and press reset. The power switch is on and working.

. Do not exceed the weight limit, climb steep slopes, or try to pull things. It is best to avoid this condition at all times.

Sewing. The power switch is not on. The device does not come out. Please try the following:

check the loose joints under the € the bridge slab.

. * If contacts are loose, reconnect them.

NO € Â If NO connections are not loose, change the reset / power switch.

Eighth The power switch is on. Please try the following:

Check the ، the chain tension, position and condition.

. * If the chain is too loose, it should be rebuilt. (See Oers Manual Page 6)

. Â If the chain is off the sprite, check the chain for damage and replace it if necessary. (See Oers Manual Page 7)

. Â If the chain is stuck in the chain tensioner (model E150 only), remove the chain from the chain tensioner, check the chain and chain tensioner for damage, and replace it if necessary. After replacing the damaged part, replace the chain on the rear axle.

Also try:

. Turn off the power and manually rotate the gearbox on the motor shaft with your fingers.

transmission Se If the transmission does not rotate freely, replace the engine.

Eighth Fast travel time, slow running, do not receive E100 / 125/150

Note The battery charges but slows down after 10-15 minutes of use and / or the device runs slowly.

Please try the following:

Passengers Check the weight and driving conditions of passengers, do not exceed the weight limit, climb steep slopes or try to carry luggage. It is best to avoid this condition at all times.

Check the air pressure in the front and rear tires. If the air pressure is low, slide the tires to the recommended PSI (located on the edge of the tire). This application is only for E150 and E100 / 125 front tires.

chain € Check the chain tension. If the chain is too tight, see page 6 of the operation manual.

چیک Check the front bearings for signs of friction in the front tire (rim). If the bearings are rubbing against each other, adjust the bearings (see page 4 of the Overseas Manual).

. Make sure the charger is securely connected to the charger port and the light is on.

My daughter E100 does not work electric. It puts a green light on the charger and clicks when it is activated but does not work. Thoughts

Razor Scooter Clicks But Wont Go

You want to replace the battery.
Check out this page I just checked the E100's battery.
My S does not move or work even when pressed, the power adapter will turn red, but when disconnected, the light will not work,
Thank you very much,
Cayman Moore
Replace the battery

Razor Scooter Clicks But Wont Go

My electric shaver E100 does not work? ^

First I charge and the indicator light is green, it's ok to charge. I have tested it and the current is flowing, but it is not moving at a speed of 5 km per hour. I think it's the connector of the device that goes to the charger because I can pull the cable and that's where I get the clicking sounds. If anyone has an answer or solution, please don't leave me. Thank you very much!

update

what shall I do ?

Troubleshooting and FAQ for E100 / e125 / e150 Shaver

I. Location of Circuit Identifier:

The uct ID is not only on the uct loader, but also under the control tube and uct.

II.E100 / 125/150 Intermittent operation: The device switches on and off during use. Please try the following:

Slowly slide the cable around the throttle to find the loose pile of cables. If the device shuts down due to vibration / loose wires, the butterfly valve must be replaced.

loose € Loose Remove the battery / engine cover to check for loose contacts. If any contacts are loose, reconnect them.

I am. E100 / 125/150 does not work:

* Always make sure that the charger is properly connected to the charging port and that the charger LED is working properly.

* This device can be charged up to 18 hours after first use and up to 8 hours after each use.

The engine will not start. Please try the following:

Speed rating 5 km per hour (in SD).

Don't forget to press s while changing the throttle control.

It shuts down during use. Please try the following:

. Turn off the device, wait a few minutes and press reset.

/ switch on / off The switch turns on and off again.

. Don't try to overweight, climb hills, or pull things. It is best to avoid this condition at all times.

The power switch is not on. The motor is not activated during kicking. Please try the following:

check the loose joints under the € the bridge slab.

. * If contacts are loose, reconnect them.

. Â If there are no loose contacts, replace the reset / power switch.

The motor starts but does not move (E150 only) Please try the following:

Check the € the chain and rear wheel a.

Â Â If the chain rotates but the rear wheel does not move, replace the rear wheel.

The device is working, but not working after charging. The power switch is on. Please try the following:

The unit secures the unit and takes no load on the S, turning the rear wheel manually while breathing and accelerating.

Â Â If the engine starts, replace the battery.

Â Â If engine does not start, replace control module and throttle body.

quiet. Do not stay silent. Press E100 / 125/150.

E100 ss series requires S stick. When the engine stops, it does not start.

. Turn on the device.

€ € Press with your feet. Make sure your body roll is good (less than 3 miles per hour). Watch the video.

Stop on the اسٹ the accelerator pedal.

. * The engine starts now.

V. E100 / 125/150

Closes during use Try the following:

. Turn off the device, wait a few minutes and press reset. The power switch is on and working.

€ the Do not exceed the weight limit, climb too far, or try to pull objects. It is best to avoid this condition at all times.

Sewing. The power switch is not on. The device will not be lost. Please try the following:

check the loose joints under the € the bridge slab.

. * If contacts are loose, reconnect them.

NO € Â If NO connections are not loose, change the reset / power switch.

Eighth The power switch is on. Please try the following:

the € the Check the tension, position and condition of the chain.

. * If the chain is too loose, it should be rebuilt. (See Oers Manual Page 6)

. * If the chain comes from the spark, check the chain for damage and replace it if necessary. (See Oers Manual Page 7)

Also try:

. Turn off the power and manually rotate the gearbox on the motor shaft with your fingers.

Â transmission If the transmission does not rotate freely, replace the engine.

Eighth Fast travel time, slow running, do not receive E100 / 125/150

Note The battery charges but after 10-15 minutes of use and / or the device runs slowly.

Please try the following:

Passengers Observe the weight and driving conditions of passengers, do not exceed the weight limit, climb steep slopes or try to carry luggage. It is best to avoid this condition at all times.

Check the air pressure in the front and rear tires. If the air pressure is low, slide the tires on the PSI (located on the edge of the tire). This application is only for E150 and E100 / 125 front tires.

chain € Check the chain tension. If the chain is too tight, see page 6 of the operation manual.

€ € Make sure the front bearing does not rub against the front tire (rim). If the bearings are rubbing against each other, adjust the bearings (see manual page 4).

. Make sure the charger is properly plugged into the charging port and the light is on

Razor Scooter Clicks But Wont Go

My phone does not want to move or move when pressed, when the power adapter has a red light, but when it is plugged in,,,,,,,,,,,,,,,,,,,,, ,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,, ,,,,,,,,,

Thank you very much,

Cayman Moore