Scunci Steamer

Am I going to fix my skin vaporizer? 3

My skin vaporizer is not working. It heats up, creates pressure, but does not evaporate. Help.

update

I got the answer to my question:

Cleaning Tools | Reader Questions> Repair | Repair> Device

Skin vaporizer does not evaporate

Continue or the steam does not come out without pressing the button to solve the fake problem and neither does the steam come out.

Knife:

1. Remove the two S from the vaporizer, then remove the closing cap.

2. Removed from the bottom of the vaporizer, remove the two s under the round rubber cap around the filling.

4. The back of the handle, the top of the vaporizer, and the front of the vaporizer to which the jet is attached.

5. Remove the plastic tube that gives off steam.

6. Now look to the left where the steam is coming from and remove the 1/4 inch nut, metal washer and rubber washer.

7. Make small movements and tap the BR handle until it comes out from behind.

8. Remove the brake rod and spring. There will be some raw meat in spring and where does it come from. Thoroughly clean and shake. This solves the problem of steam escaping without pressing a button.

9. Clean the stem, spring and housing. I used a very small round wire brush. Like the type you can use to clean up files.

10. Spray WD40 on the left ■■■■■■■■ and ■■■■■■■■ BR, then put a few drops of oil on the ■■■■■■■■.

11. Send everything back and it will work like new. Otherwise, throw it away and buy it the right way.

I would like to add two more issues:

On my vaporizer, there is a strangely shaped head at the bottom of the handle. Luckily I have a set of conductive tips and for that I need a flat tip with an E-cut in the middle. With this tip, I can remove it and replace it with a normal Phillips head that fits into another one.

Once removed, there is no way to remove the bottom of the handle. At the end of the day, I decided to do a little tourniquet on both sides of the ■■■■■ on this part of the inferior cover of the poignée and j'ai j'ai poussé le conductor.

Holy steam. To repair

The best guide. I want to finish

1, it is necessary to grind 1/4 screwdriver to tighten the steam nut.

2, remove the nut 1 1/2 turns to use the surface of the nut to allow it.

Protecting shank threads reduces the chances of the ■■■■ slipping from the shank and damaging the steam.

3, pay attention to the shaft stroke after each contact. When finished, remove the nut and washer and use pliers to pull the shaft out.

Daily

I can't open my vaporizer. It was in storage and I couldn't run the lid of the tank which closed the water tank.

Scunci Steamer

I just added a step that helped me a lot.
6. I used a 6mm extension shaft and it worked perfectly to remove the screws. (Closing the other end with tweezers)
7. Take out all the rubber parts and soak them in vinegar for a few minutes, then wash with water and dry with a cloth or paper towel.
I have a model 1600 R cartridge. Where can I buy a replacement if I have one? I didn't do anything on the internet for 2 hours.
Oh, I wasn't going to spray at first. I fixed it, but now it's frozen.